Marvel MP24FAS4LS Manuale e Manuale per l'Utente Pagina 4

  • Scaricare
  • Aggiungi ai miei manuali
  • Stampa
Vedere la pagina 3
4
INSTALLING YOUR REFRIGERATOR
Select Location
The proper location will ensure peak performance
of your refrigerator. We recommend a location
where the unit will be out of direct sunlight and
away from heat sources. To ensure your product
performs to specications, the recommended
installation location temperature range is from 55 to
100°F (13 to 38°C) for indoor units and 55 to 115°F
(13 to 46°C) for outdoor units.
Cabinet Clearance
Ventilation is required from the bottom front of the
refrigerator. Keep this area open and clear of any
obstructions. Adjacent cabinets and counter top
can be installed around the refrigerator as long as
the front grille remains unobstructed.
Front Grille
Do not obstruct the front grille. The openings within
the front grille allow air to ow through the con-
denser heat exchanger. Restrictions to this air ow
will result in increased energy usage and loss of
cooling capacity. For this reason it is important this
area not be obstructed and the grille openings kept
clean. Northland does not recommend the use of
a custom made grille as air ow may be restricted.
(See Figure 2).
!
CAUTION
Front Leveling
Legs
Figure 2
Rear
Leveling
Legs
Front Grille, keep
this area open.
Leveling Legs
Adjustable legs at the front and rear corners of
the appliance should be set so the unit is rmly
positioned on the oor and level from side to side
and front to back. The overall height of your Marvel
appliance may be adjusted higher (by turning the
leveling leg out, CCW) and lower (by turning the
leveling leg in, CW) dimensions as shown in Table
"A".
To adjust the leveling legs, place the appliance on a
solid surface and protect the oor beneath the legs
to avoid scratching the oor. With the assistance of
another person, lean the appliance back to access
the front leveling legs. Raise or lower the legs to
the required dimension by turning the legs. Repeat
this process for the rear by tilting the appliance
forward using caution. On a level surface check the
appliance for levelness and adjust accordingly.
The front grille screws may be loosened and the
grille adjusted to the desired height. When adjust-
ment is complete tighten the two front grille screws.
(See Figure 5).
Model Door Style
Minimum
Height
Maximum
Height
MP24* (S)
34"
(86.4 cm)
35"
(88.9 cm)
MP24* (P)
34"
(86.4 cm)
35"
(88.9 cm)
Table A
An optional stacking kit, for 24" wide models,
is required to stack products. Failure to use a
stacking kit could result in personal injury. Con-
tact your dealer or Northland customer service
at 844-875-7064 to order.
!
WARNING
Vedere la pagina 3
1 2 3 4 5 6 7 8 9 ... 71 72

Commenti su questo manuale

Nessun commento